Preamble
Yes, I know, I'm using the "Split lines / ..." function not in the correct way; I'm really missing the trim-line-to-next-point function most CAD programs have *; but this is far from the failure mode I expected .... it didn't do that previously and just created a zero-length edge instead of crashing after a message box invasion.
* some things are much easier and faster to draw that way
System information
- SolveSpace version: 3.1~3833dd02 (built a few minutes ago)
- Operating system: W10 22H2
Expected behavior
From optimal to worst:
- just split the one line at the endpoint of the second line
- create zero-length line segment like previous versions
- error out ("can't do that")
Actual behavior
Additional information
🙏〰✂
Preamble
Yes, I know, I'm using the "Split lines / ..." function not in the correct way; I'm really missing the trim-line-to-next-point function most CAD programs have *; but this is far from the failure mode I expected .... it didn't do that previously and just created a zero-length edge instead of crashing after a message box invasion.
* some things are much easier and faster to draw that way
System information
Expected behavior
From optimal to worst:
Actual behavior
Additional information
🙏〰✂