Repository navigation
pushing a new bug to github via git-bug-bridge then pulling back down duplicates the bug #690
Description
after setting up a bridge to github using a authtoken (i believe it was option number 3 in bridge-configure) i ran the following commands
git bug bridge push
git bug bridge pull
git bug ls
outputs the following
70864ca open Mirror Select list exits unexpectedly Jacob Stannix 1 💬
8009d53 open program will erase drive with existing partitions… Jacob Stannix 1 💬
a74b02b open Mirror Select list exits unexpectedly Jacob Stannix 1 💬
5076442 open program will erase drive with existing partitions… Jacob Stannix 1 💬
issue only appears when a bug created by git-bug is pushed to github and pulled back down. Does not occur when the issue is created on github's side
Activity
MichaelMure commentedon Jul 5, 2021
Which version are you using?
delta1024 commentedon Jul 6, 2021
0.7
MichaelMure commentedon Jul 8, 2021
If you could try with the development version (master) it'd be nice. This is most likely fixed already.
delta1024 commentedon Jul 16, 2021
I went and downloaded the latest stable release and installed it. I then went and created a test issue then configured the bridge.
I've included the commands i used and their output below.
( I went and closed the issue on git hub then entered these commands)
afterwards i went and tested on a separate repo without closing the issue and the result was the same only the new issue was open instead.